Two-component, water-dilutable anti-slip acrylic enamel topcoat designed for decorative and durable coating of metal surfaces with matte finish, UV resistance and mechanical durability.
5:1(by weight)
min. 2 hours
Stage 1: max. 1h
5 days
24 hours
Available as a colored, homogeneous anti-slip topcoat system with a matte finish for metal surface applications.
| Product type | Two-component, chemically curing anti-slip acrylic enamel topcoat |
| Binder system | Water-dilutable reactive acrylic resin with aliphatic water-emulsifiable polyisocyanate |
| Finish | Anti-slip, matte finish |
| Mixing ratio (A:B) | 5 : 1 by weight |
| Gel time / Pot life (20°C) | Must not gel within 2 hours |
| Drying time (20°C) | Stage 1: max. 1 h / Stage 6: max. 24 h |
| Recoating interval | 24 hours at 20°C / 1 hour at 60°C |
| Maximum film thickness | 35 – 40 μm per layer; single layer must not exceed 80 μm |
| Full curing time (20°C) | 5 days |
| Full curing time (50–70°C) | 1 – 1.5 hours |
| Coating appearance | Uniform, high gloss according to datasheet |
| Adhesion | Grade 0 |
| Flexibility, Erichsen | min. 5 mm |
| Impact resistance | min. 40 cm / 1000 g |
| Gloss at 60° | ≥ 90 |
| Hardness, Persoz pendulum | min. 50% |
| Chemical resistance | Fully cured coating is resistant to water, petrol and oil |
| Coverage | 7 – 8 m²/kg |
| Recommended application | Single layer recommended; brush, roller or spray application possible |
| Application temperature | Substrate temperature above +10°C |
| Dilution | Deionized water, conductivity ≤ 20 µS/cm; approx. 20%, max. 30% |
| VOC content | max. 140 g/l |
| Shelf life | 12 months from date of manufacture; frost-sensitive, do not store below 5°C |
Before application, metal surfaces must be properly prepared. Existing coatings should be checked with a preliminary test application to verify adhesion and possible surface reactions. The product can be applied by brush, roller or spray after dilution with deionized water.
Detalied technical documents and test reports are available for download.
Application in a single layer is recommended; however, the film thickness must not exceed 80 μm. Applying a thicker layer in one step without intermediate drying may result in bubbling or pinholing.
Our team is ready to help you find the best coating solution for your project.
This product is supplied as an exclusive distribution prodct ins partnership with:
