Two-component black antistatic protective coating designed for corrosion protection and electrostatic charge dissipation on industrial surfaces exposed to mechanical, chemical and mineral oil loads.
2,5:1(by weight)
min. 3 hours
Stage 1: max. 1 h
24 hours
approx. 60 min
| Product type | Two-component black antistatic protective coating |
| Component A appearance | Black-colored, paste-consistency suspension |
| Component B appearance | Yellowish liquid |
| Mixing ratio (A:B) | 2.5 : 1 (by weight) |
| Gel time / Pot life (20°C) | Must not gel within 3 hours |
| Drying time (20°C) | Stage 1: max. 60 min / Stage 6: 24 hours |
| Drying time (70°C) | 60 minutes |
| Adhesion | Grade 0 |
| Flexibility, Erichsen | 6 mm |
| Impact resistance | min. 60 cm / 1000 g |
| Discharge resistance | max. 10⁵ Ω at 100 μm dry film thickness on metal surface |
| Heat resistance | Continuous exposure up to 100°C / intermittent exposure up to 120°C |
| Chemical resistance | Natural gas unchanged; permanently resistant to mineral oils |
| Mineral oil resistance | Permanently resistant to gasoline, diesel fuel, engine oil and kerosene |
| Coverage | 5 – 8 m²/kg |
| Application temperature | Above +10°C recommended |
| Thinner | Epamin 214 thinner |
| Spray application thinning | Up to 20% Epamin 214 thinner may be added |
| VOC content | 650 g/l |
| Storage warranty | 2 years from date of manufacture |
| Packaging | Component A: net 2.5 kg / Component B: net 1 kg |
| Color | Black |
Before application, steel surfaces must be derusted and degreased. When recoating existing coatings, preliminary test applications are recommended to check adhesion and possible substrate compatibility. The two components must be mixed in the prescribed ratio and processed within the available pot life.
under a load of 1000 g using a cs17 wheel, the wear loss after 1000 cycles was appormately 61,6 mg – indicating excellent abrasion resistance.
Detalied technical documents and test reports are available for download.
Under outdoor exposure and sunlight, the black antistatic coating may brown, become matte or chalky. This does not indicate a loss of protective performance. Surfaces exposed to sunlight should be overcoated with a suitable CATEPOX antistatic topcoat in one layer.
Our team is ready to help you find the best coating solution for your project.
This product is supplied as an exclusive distribution prodct ins partnership with:
